The CB-3000 is the new smaller design of The Curve.

Customer demand was high for a size mid-way between the CB-2000 and The Curve. The result is the CB-3000. It represents the natural lines of the penis. It is extremely transparent which makes it very intriguing while being worn. The slope makes it virtually undetectable under clothing. Take the time to find the right sized cuff ring and the proper spacing to get the exact custom fit. We recommend The Curve for above average and large sized men.

You should use baby oil/jell, silicon based lube, or a similar product after showering, applying to the penis with a cotton swab. This allows the penis to naturally move up and down in the cage portion. After this has been accomplished you should be able to wear it 24/7 for indefinite periods of time...1 months, 3 months...wearer and Keyholder ultimately determine the period of time!

The material is a highly durable polycarbonate. It is very light weight which adds to the comfort. It is vented with slots allowing natural air drying. The design also allows for hygiene when bathing. Use a soapy sponge or cloth to allow the soap and water to clean the interior of the cage.

If traveling, make sure to wear a numbered plastic lock if going through metal detectors. It has been reported that some men have worn the brass padlock and have not had any "alarming"e; experiences, however, the plastic lock is still recommended.

The CB-3000 consists of two parts:

Cuff Ring

The Cuff Ring comes in five sizes: 1 1/2 inches, 1 5/8 inches, 1 3/4 inches, 1 7/8 inches & 2.0 inches. All the five sizes come with each order. This allows the wearer to experiment to find his exact size. The rings swivel at the bottom making it easy to put on. Each ring consists of two guide pin holes and a recessed locking pin hole. Spacers are provided for an individual fit. These spacers go over the locking pin, between the cuff ring and the cage.

Cage Portion (inside length 3 inches - inside diameter 1 3/8 inches)

The cage portion has two guide pins and a locking pin hole. The cuff ring goes behind the ball sack and over the penis. Install the locking pin and the spacers. Put the cage over the penis and then line up the cage portion with the cuff ring. Slide the guide pins and locking pin into place and attach a lock on the tip of the locking pin. Once you have found the exact fit, cut the ends of the guide pins with a pair of side cutter pliers and smooth the edges with an emery board.

Note: Some men have a high tight ball sack. If this is the case it may take a little longer to get a comfortable exact fit. For the best results the ball sack should hang slightly beneath the cuff ring and cage portion. You may find it necessary to stretch the ball sack. This can be accomplished by using our parachute ball stretcher or other ball stretcher devices.

Now offered are the Points of Intrigue for the CB3000. See below.